Graphicautomations.com

CUTTING MACHINE KNIFE/BACKGUAGE CONTROLLER REPLACEMENT

PRINTCUT Guillotine Backgauge Control AC Servo System:

This is a complete servo control system with all cables pre-made and with industrial connectors for easy, fast and reliable installation. The system is fully tested as a kit before leaving our factory to ensure all you have to do is mount the parts, plug the cables in and connect up to the electricity supply. The kit includes the servo motor with an encoder mounted at one end and a toothed pulley mounted on the output shaft. Installation of the motor is straightforward as we provide a mounting bracket with the motor which is then fixed to the back of the machine close to the leadscrew.

Electrical installation is also straightforward and requires only mounting the controller and electrical cabinet,  positioning the sensors using the brackets provided, then  plug the cables to their corresponding socket on the electrical cabinet. If the Jog Wheel option has been purchased, this would then need to be mounted and plugged into it's corresponding connector. This then allows the user fine positional control of the cut position. An adjustment can then be stored as an offset to use on the next batch if required.

Software setup is generally straightforward as initial setup will have been done at the factory. All that remains for the user to do is set the size of the machine, the 'Play' for worn leadscrews, some motor settings may need changing depending on manufacturer used and finally calibrating to the machine. Once the easy to follow instructions have been completed, cut programs can then be entered and run or stored for future use.

The following VEDIO shows the data available in the run mode for easy cutting.

 

CUTTING MACHINE CONTROLLER